Mitsubishi Electric MELSEC iQ-R Series User Manual page 109

Item
Safety Data Transfer Receive Data
Device Setting Storage Device
Send Data Storage
Device
Safety Authentication Code
[Output to File (for Setting Confirmation)]
button
*1 If the setting cannot be confirmed in the module parameters and "Network Configuration Settings", a hyphen may be displayed or the
displayed calculation result may not be correct.
*2 Set the safety connection No. starting with 1.
Even if the safety connection is set in a random line, the unset line is deleted and the No. is set starting with 1 when the [OK] button is
clicked.
*3 When the setting of IP address and PLC No. is one of the following, an error is displayed on the engineering tool.
The same IP address is set and PLC No. setting is empty.
The same IP address and PLC No. are set.
*4 Safety communications are sent/received in increments of 32 points, however a safety data transfer device setting can be set in
increments of 16 points.
Description
Set a safety device of the Safety CPU where safety data are
received.
Set a safety device of the Safety CPU where safety data are
sent.
This code is used to identify the communication destination
when safety communications perform. Set the same value in the
master station and device station to perform the safety
communications.
Outputs the contents of the safety communication setting to a
CSV file. The file is used to check whether there is no
discrepancy between the safety communication setting written to
the Safety CPU and that of the project.
( GX Works3 Operating Manual)
Setting range
■Device name
• SA\X
• SA\M
• SA\B
• SA\D
• SA\W
(Default: empty)
■Points
• Bit device: 16 to 128 (set in increments of
*4
16 points)
• Word device: 1 to 8 (set in increments of
1 point)
(Default: empty)
■Start/End
Range of a safety device in the Safety CPU
(Default: empty)
■Device name
• SA\Y
• SA\M
• SA\B
• SA\D
• SA\W
(Default: empty)
■Points
• Bit device: 16 to 128 (set in increments of
*4
16 points)
• Word device: 1 to 8 (set in increments of
1 point)
(Default: empty)
■Start/End
Range of a safety device in the Safety CPU
(Default: empty)
0 to FFFFFFFFH
(Default: empty)

2 PARAMETER SETTINGS
2.3 Basic Settings
2
107