Table of Contents
Advertisement
Stratasys J826 User Guide
The waste container consists of a sealed bag inside a cardboard box. You
typically dispose of the entire waste container—including the box. Therefore,
you must assemble a new box and insert a new waste bag before you can
install it in the printer.
Replacement boxes, waste bags, and sealing caps are supplied in the
printer start-up kit and in the preventive-maintenance kit.
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
2. Fold a new waste bag—so it fits in the box—and insert the bag's screw-
To replace the waste container:
1. Push the door of the lower printer compartment to open it.
2. Carefully slide out the waste container to remove it from the printer.
3. Place the new waste container next to the full container.
DOC-28000 Rev. I
sections.
connector into the hole in the top of the box.
Note: Do not close the box until you connect the waste drain tube from the
printer.
Figure 4-192 Waste container under the printer
Figure 4-193 Waste container removed from the printer
4 Operating and Maintaining the Printer
4-132
Advertisement
Table of Contents
