Table of Contents
Advertisement
Stratasys J826 User Guide
If the UV level measured is not acceptable, the wizard calibrates the UV lamp
by adjusting the current supplied to it, and then tests it again.
When all UV tests have finished, the results are displayed, showing the
condition of the lamps after calibration (see Figure 4-119 below).
Figure 4-119 Results and condition of UV lamps after calibration
After examining the UV calibration results:
1. Click Next.
2. Remove the UV sensor and close the printer cover. After confirming the
DOC-28000 Rev. I
items listed in the wizard screen, click Next.
Figure 4-120 UV sensor removal
If the results are not acceptable for quality printing, this is indicated in the
final wizard screen.
4 Operating and Maintaining the Printer
4-84
Advertisement
Table of Contents
