Stratasys J826 User Manual page 133

Stratasys J826 User Guide
3. Make sure that the build tray is empty, and confirm this in the wizard
4. Select the UV lamp(s) to be replaced and click Next.
5. Disconnect the UV-lamp power connector and the UV heat fuse connector.
DOC-28000 Rev. I
screen. Then, close the printer, and click Next.
Figure 4-151 Tray confirmation
The axes move to the "home" position.
Figure 4-152 UV lamp selection screen
Figure 4-153 Disconnecting the UV lamp
4 Operating and Maintaining the Printer
4-103