Stratasys J826 User Guide
9. Remove the UV lamp bulb from the UV reflector.
10. Before continuing, inspect the spring-loaded pins. If there are burn marks
DOC-28000 Rev. I
Figure 4-157 Removing the UV lamp bulb
around the pins or if the pins are loose—their springs are not functioning
properly—and do not support the bulb, continue with step
UV reflector.
Otherwise, continue with step
Figure 4-158 Spring-loaded pin
4 Operating and Maintaining the Printer
to replace the UV lamp bulb.
11
, to replace the
15
4-105