Table of Contents
Advertisement
Stratasys J826 User Guide
15. Remove the tube holder, with the tube, from the pump assembly.
16. Remove the tube from the tube holder and save the two parts of the clamp
17. Carefully detach the tube at both ends. Use the cleaning cloths to prevent
18. Remove and save the part of the fitting remaining on the pump tube.
19. Discard the old tube and the cleaning cloths.
These items contain uncured printing material. Dispose of them in
accordance with environmental and safety requirements.
20. Place the tube clamp onto the new tube, and insert it into the tube holder,
DOC-28000 Rev. I
for re-assembly.
Figure 4-141 Pump tube secured with the clamp in the holder
material leaking from the tubes.
Figure 4-142 Detaching the tube
making sure that the flat surface of the clamp faces outward (see Figure 4-
141 above).
4 Operating and Maintaining the Printer
4-96
Advertisement
Table of Contents
