Table of Contents
Advertisement
Stratasys J826 User Guide
11. When scanning is finished, select Scan other images in the dialog box
If this dialog box does not appear, click Preferences (at the bottom of the
interface) and in the Scan tab, select Display the dialog to select next
action.
12. Remove the transparency from the scanner, and place the reference (grid)
13. Close the scanner lid.
14. Click Scan.
15. When scanning is finished, select Scan other images in the dialog box
16. Place the test-pattern transparency face up on the scanner platen, with the
17. Place the A4 sheet of black plastic, glossy-side down, on top of the
18. Close the scanner lid.
19. Repeat steps 8–14.
DOC-28000 Rev. I
and click OK.
Figure 4-181 Selection after scanning the test pattern
transparency on the scanner platen, next to the bottom and left borders.
Note: Do not adjust the cropping frame (scan area). The scanning size
must remain the same as for the test-pattern scan.
and click OK.
arrows aligned with the black rail (under the glass), and the edge marked
'This Face Up - B' along the bottom edge of the scanner glass (closest to
you). See Figure 4-178 on page 4-117.
Make sure that the bottom edge of the transparency is at the border of the
platen.
transparency. Do not move the transparency.
4 Operating and Maintaining the Printer
4-119
Advertisement
Table of Contents
