Stratasys J826 User Manual page 105

Stratasys J826 User Guide
25. In the next wizard screen, confirm that you have removed all tools and
26. Close the printer cover.
27. After replacing print heads, you should run the wizard again, to optimize the
Installation Problems
If the printer detects that there is a problem after you install print heads, a
relevant warning screen appears.
➢ If the printer software does not detect the replaced head, release the print
DOC-28000 Rev. I
objects from the printer.
Figure 4-105 Cleared-tray confirmation screen
The wizard continues by heating the heads, then filling and purging them.
If installation problems are detected, the wizard alerts you and instructs you
how to continue (see "Installation Problems" below).
new heads, and to make sure that they are optimized for printing with the
other heads. In the final wizard screen, select Optimize all print heads
and click Next.
Figure 4-106 Final wizard Screen
head card and re-insert it. (see "Removing the Defective Head" on page 4-
69).
4 Operating and Maintaining the Printer
4-75