Table of Contents
Advertisement
Stratasys J826 User Guide
Replacing the Waste Container
Printer waste contains partially cured polymeric material, collected during
normal operation and maintenance of the printer. For safety and environmental
reasons, this material is kept in a special leak-proof, disposable container.
The container has a capacity of about 8 kilograms of waste material—usually
enough for several months of printer use. The printer application displays a
warning message when there are 7.3 kilograms of material in the container,
and stops the printing when the net weight reaches 7.8 kilograms. Above 7.3
kilograms, the software does not allow you to start a printing job or activity until
you replace the waste container.
You can monitor the weight of the waste container in the Printer Indicators
display in the printer interface. You can also visually inspect the level of waste
in the container. To access it, see page 4-132.
To monitor the waste weight (and other indicators) in the printer:
➢ In the main printer interface screen, click the display toggle to view the
Figure 4-191 Printer interface, showing waste weight (red background
indicates operator alert)
DOC-28000 Rev. I
printer indicators.
4 Operating and Maintaining the Printer
4-131
Advertisement
Table of Contents
