Table of Contents
Advertisement
ENTER/EXIT PROGRAMMING MODE
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
page 275
Select ACK Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
page 276
Select NAK Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
46
POWERSCAN™ PD/PM96XX
for more detailed programming instructions.
NOTE: Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit data
is not recognized when the option " Data Bits" on page 39 has been set as 7
Data Bits.
0x06 'ACK' Character
for more detailed programming instructions
NOTE: Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit data
is not recognized when the option " Data Bits" on page 39 has been set as 7
Data Bits.
0x15 'NAK' Character
RS-232/USB-COM INTERFACES
ACK Character" on
$CR2AC
CANCEL
NAK Character" on
$CR2NA
CANCEL
Advertisement
Table of Contents
