Ack Character; Nak Character - Datalogic QuickScan 2500 Series Product Reference Manual

RS-232/USB-COM SETTINGS

ACK Character

This setting specifies an ASCII character or hex value to be used as the ACK character.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
page 263
Select ACK Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

NAK Character

This setting specifies an ASCII character or hex value to be used as the NAK character.
ASCII characters or any hex value from 0 to 0xFF can be selected. See "
page 264
Select NAK Character Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
for more detailed programming instructions.
NOTE: Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit data
is not recognized when the option " Data Bits" on page 32 has been set as 7
Data Bits.

0x06 'ACK' Character
for more detailed programming instructions
NOTE: Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit data
is not recognized when the option " Data Bits" on page 32 has been set as 7
Data Bits.

0x15 'NAK' Character
ENTER/EXIT PROGRAMMING MODE
ACK Character" on
$CR2AC
CANCEL
NAK Character" on
$CR2NA
CANCEL
PRODUCT REFERENCE GUIDE
39