Table of Contents
Advertisement
19. Install the server.
20. Connect all peripheral cables to the server.
21. If removed, connect the tube set.
22. Power up the server.
The installation is complete.
OCP NIC 3.0 adapter option
The server supports SFF dual-port and quad-port OCP NIC 3.0 adapter options with various interfaces and advanced
interconnect features for high-bandwidth applications.
Installing the OCP NIC 3.0 adapter
Prerequisites
Before you perform this procedure, make sure that you have a plastic spudger available.
Procedure
1.
Power down the server.
2.
If installed, disconnect the tube set.
3.
Disconnect all peripheral cables from the server.
4.
Remove the server.
5.
Place the server on a flat, level work surface.
6.
Remove the node cover.
7.
Remove the primary riser.
8.
Remove the OCP 3.0 NIC adapter blank:
a. Use a plastic spudger to pry the top side of the blank from the server tray (callout 1).
b. Remove the blank (callout 2).
Retain the blank for future use.
9.
Install the OCP NIC 3.0 adapter:
Hardware options installation
70
Advertisement
Table of Contents
