Table of Contents
Advertisement
3. Do one or both of the following:
If the onboard SATA cable or a Smart Array controller cable is attached to the riser, connect the cable.
•
If a cooling loop is installed, connect the pump-cold plate signal cables to the riser.
•
Install any DIMM that might have been removed to access the pump-cold plate signal connectors.
Install the primary riser
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. Install the primary riser:
a. Align the spools on the riser with the notches on the server tray (callout 1).
b. Carefully press the riser down on its system board connector (callout 2).
Make sure that the riser board is firmly seated.
c. Install the riser screws (callout 3).
31
Operations
Advertisement
Table of Contents
