HPE ProLiant XL225n Gen10 Plus User Manual page 85

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center website (https://
www.hpe.com/support/hpesc). To update the system ROM, follow the instructions on the website.
3. Power down the server.
4. If installed, disconnect the tube set.
5.
Disconnect all peripheral cables from the server.
6. Remove the server.
7. Place the server on a flat, level work surface.
8. Remove the node cover.
9.
If either an expansion card or a cooling loop bracket is installed on the primary riser is blocking the TPM connector,
remove the riser.
10. Proceed to "Installing the TPM board and cover."
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION: If the TPM is removed from the original server and powered up on a different server, data stored in the
TPM including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a different
orientation might result in damage to the TPM or system board.
2. Install the TPM board:
a. Locate the TPM connector on the system board. See the server hood label for the exact location.
b. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM
board firmly into the connector.
Hardware options installation
85