Table of Contents
Advertisement
◦
If a static IP address is assigned, use that IP address.
◦
The default login credentials are on the serial number/iLO information pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
Power on the server
9.
Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
10. Using the SPP, update the following:
•
System ROM
•
Storage controller
•
Network controller
Set up the storage
11. Set up the storage. Do one of the following:
•
To configure the server to boot from a SAN, see the following guide:
https://www.hpe.com/info/boot-from-san-config-guide
•
If an HPE Smart Array controller is installed, use the HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator.
•
If no controller option is installed, do one of the following:
◦
AHCI is enabled by default. You can deploy an OS or virtualization software.
◦
Disable AHCI, enable software RAID, and then create an array:
a. From the boot screen, press F9 to run UEFI System Utilities.
b. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) >
Storage Options > SATA Controller Options > Embedded SATA Configuration.
c. From the SmartRAID SW RAID Support drop-down menu, select Enable, and then click OK.
If you see a warning regrading Legacy BIOS mode, click OK.
d. Save the configuration and reboot the server.
e. Create an array:
I.
From the boot screen, press F9 to run UEFI System Utilities.
II.
From the System Utilities screen, select System Configuration > Embedded Storage: HPE SR100i
Gen10 Plus SW RAID > Array Configuration > Create Array.
Deploy an OS or virtualization software
12. Deploy an OS or virtualization software:
a. Do one of the following:
39
Setup
Advertisement
Table of Contents
