Table of Contents
Advertisement
Remove the primary riser
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless either riser blank or riser
cage is installed.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
T-10 Torx screwdriver
•
T-15 Torx screwdriver
Procedure
1. Power down the server.
2. If installed, disconnect the tube set.
3. Disconnect all peripheral cables from the server.
4. Remove the server.
5. Place the server on a flat, level work surface.
6. Remove the node cover.
7. If an expansion card with internal cable is installed on the riser, disconnect the cable from the expansion card.
8. Remove the riser screws (callout 1), and then lift the riser off the system board (callout 2).
27
Operations
Advertisement
Table of Contents
