Table of Contents
Advertisement
a. Pivot the spring loaded force frame downward and hold it down (callout 1).
b. Use a T-20 Torx screwdriver to tighten the captive screws in the sequence shown in the following image (callouts 2–
4).
When using a torque wrench to tighten the screws, apply a torque of 1.58 N⋅m (14 lbf-in).
11. Install the heatsink.
Installing a heatsink
The heatsinks for processors 1 and 2 are not interchangeable. To identify the correct heatsink for each processor, see the
heatsink label. Also, note the markers on the T-shaped heatsink numbering pointer to identify the processor socket number.
Prerequisites
Before you perform this procedure, make sure that you have a T-20 Torx screwdriver available.
Procedure
1. Remove the thermal interface protective cover from the new heatsink.
2. Install the heatsink:
Hardware options installation
75
Advertisement
Table of Contents
