Table of Contents
Advertisement
Procedure
1. Power down the server.
2. If installed, disconnect the tube set.
3. Disconnect all peripheral cables from the server.
4. Remove the server.
5. Place the server on a flat, level work surface.
6. Remove the node cover.
7. If installed, remove the air baffle.
8. Do one of the following:
•
If a cooling loop is installed, disconnect the pump-cold plate signal cables from the riser.
If necessary, remove the DIMM adjacent to the riser to access the pump-cold plate signal connectors.
•
If the onboard SATA cable is attached to the riser, disconnect it from the system board.
•
If an expansion card with internal cable is installed on the riser, disconnect the cable from the expansion card.
9. Remove the riser screws (callout 1), and then lift the riser off the system board (callout 2).
There is a hole on the front end of the riser bracket for finger access in pulling up the riser.
29
Operations
Advertisement
Table of Contents
