Ocp Network Adapter Option; Installing The Ocp Network Adapter - HPE AR44z User Manual

The Red Hat and SUSE links listed here will take you outside the Hewlett Packard Enterprise website.
Hewlett Packard Enterprise has no control over and is not responsible for information outside the Hewlett
Packard Enterprise website.

OCP network adapter option

Installing the OCP network adapter

CAUTION: EMI disturbs the normal functioning of an electronic device. To maintain proper EMI
shielding, do not operate the system when the QSFP port knockout or the OCP network adapter is
not installed.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Flathead screwdriver
• T-15 Torx screwdriver
Procedure
1. Power down the server on page 14.
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis.
4. Using a flat screwdriver, toggle the QSFP port knockout to loosen it, and then pull the knockout out of
the rear bracket.
5. Install the OCP air baffle.
32 Hardware options installation