Table of Contents
Advertisement
CAUTION: Heatsink screws must be tightened and loosened in alternating sequence. Do not overtighten the
screws as this might damage the system board or the processor socket.
a. Position the heatsink on top of the processor, ensuring that it is properly seated before securing the screws.
b. Use a T-20 Torx screwdriver to tighten the captive screws in the sequence specified on the heatsink label.
When using a torque wrench to tighten the screws, apply a torque of 1.58 N-m (14 lbf-in).
16. Install any components or cables previously removed to access the processor socket.
17. Install the system board module access panel.
18. Install the system board module into the chassis.
19. Connect all peripheral cables to the server.
20. Power up the server.
The installation is complete.
More information
Remove the system board module from the chassis
Remove the system board module access panel
Install the system board module access panel
Install the system board module into the chassis
OCP NIC 3.0 adapter option
The server supports SFF dual-port and quad-port OCP NIC 3.0 adapter options with various interfaces and advanced
interconnect features for high-bandwidth applications.
Installing the OCP NIC 3.0 adapter option
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Hardware options installation
75
Advertisement
Table of Contents
