Installing An Ocp 3.0 Adapter Card - HPE ProLiant DL380 Gen10 Plus User Manual

Installing an OCP 3.0 adapter card

Installing an OCP 3.0 adapter card
Prerequisites Prerequisites
Before you begin this procedure, make sure that the components included with the hardware option kit are available.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel .
5. Remove the rear wall blank or riser.
6. Remove the OCP 3.0 adapter blank.
7. Install the OCP 3.0 adapter.
Installing an OCP 3.0 adapter card 187