Table of Contents
Advertisement
https://www.hpe.com/support/safety-compliance-enterpriseproducts
Read the system operational requirements.
•
Read the server warnings and cautions.
•
Procedure
Unbox the server
1.
Unbox the server and verify the contents:
•
Server
•
Documentation
Install the hardware options
2.
(Optional) Install the server hardware options. For installation instructions, see Hardware options installation.
3.
If you are installing the new server in a new chassis, install the rack rails, and then install the chassis into the rack.
See the HPE Apollo 2000 Gen10 Plus System Rack Rail Kit Installation Instructions:
https://www.hpe.com/support/apollo2000gen10plus-rackrail
Install the server
4.
Remove the server blank.
5.
Install the server.
6.
Connect all peripheral cables to the server.
7.
If the server is using a DLC cooling loop, connect the tube set.
8.
Decide how to manage the server:
•
Locally: Use a KVM switch or a connect a keyboard, monitor, and mouse.
•
Remotely: Connect to the iLO web interface and run a remote console:
a. Verify the following:
◦
iLO is licensed to use the remote console feature.
If iLO is not licensed, visit the HPE website:
https://www.hpe.com/info/ilo
◦
The iLO Management Port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
◦
The iLO hostname is on the serial number/iLO information pull tab.
◦
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
38
Setup
Advertisement
Table of Contents
