Table of Contents
Advertisement
◦
T-10 Torx screwdriver
◦
T-15 Torx screwdriver
Procedure
1.
Power down the server.
2.
If installed, disconnect the tube set.
3.
Disconnect all peripheral cables from the server.
4.
Remove the server.
5.
Place the server on a flat, level work surface.
6.
Remove the node cover.
7.
Remove the primary riser.
8.
Remove the riser slot blank:
a. Remove the retainer bracket screw (callout 1).
b. Remove the retainer bracket (callout 2).
c. Pull out the slot blank (callout 3).
9.
If installed, remove the full-height bracket from the expansion card.
10. Install the low-profile bracket on the expansion card.
Hardware options installation
65
Advertisement
Table of Contents
