Install the server
CAUTION: To avoid accidentally dropping the server, observe the following:
•
Always support the bottom of the server when removing and sliding it into the server bay.
•
Do not use the release lever as a handle to carry the server.
Procedure
1. Determine the correct orientation for the server installation.
2. If you are installing a server in a system that is operational with fewer than four servers, remove the server blank.
3. Install the server:
a. Slide the server into the chassis (callout 1).
b. Close the release lever (callout 2).
c. Tighten the release lever thumbscrew (callout 3).
34
Operations