Table of Contents
Advertisement
•
Expansion card
•
Smart Array type-p controller
14. Install the secondary riser:
a. Align the spools on the riser with the notches on the server tray (callout 1).
b. Carefully press the riser down on its system board connector (callout 2).
Make sure that the riser board is firmly seated.
c. Install the riser screws (callout 3).
15. Install the air baffle.
16. Install the node cover.
17. Install the server.
18. Connect all peripheral cables to the server.
19. Power up the server.
The installation is complete.
Storage controller cable options
The server supports two types of storage controller cables:
•
SATA controller cable—Required for SATA drive support through the embedded SATA controller chipset. This cable is
required in both AHCI and Dynamic Smart Array RAID modes.
•
SlimSAS controller cable—Required for Smart Array type-p controller installation.
Installing a storage controller cable
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Hardware options installation
54
Advertisement
Table of Contents
