14 Fault Messages & Troubleshooting; Overview - Henny Penny FlexFusion FPG-221 Service Instructions Manual

Fault messages & troubleshooting
14 Fault messages & troubleshooting

14.1 Overview

No. Fault message displayed
694 Cooking sensor defective
695
696 Top cooking chamber sensor defective
728
697 Bottom cooking chamber sensor defective
729
699 Core temperature sensor defective
700
701 Fan defective. Cooking program was canceled
702 Fan defective or temperature limiter triggered
703 Top fan defective. Automatic switching to
emergency operation
705
704 Bottom fan defective. Automatic switching to
emergency operation
706
709 Water pressure too low
Water pressure during WaveClean too low
710 Vapour sensor defective
714 Internal core temperature sensor defective
716
715 External core temperature sensor defective
717
5007 Not enough storage space for software update
5008 No new version found
5009 Application failed to start within the startup time.
Restarting the application.
5010 Application failed to start within the startup time.
Restore backup?
5013 Application recovery failed! Restore to factory
settings with OK.
FAN_ID23 Fan error: Attempt to restart
FAN_ID24 Top fan fault: Attempt to restart
FAN_ID25 Bottom fan fault: Attempt to restart
GAS_ID Gas error
12
82
Section
Cooking chamber sensor defective (694, 695)
Top cooking chamber sensor defective (696, 728)
Bottom cooking chamber sensor defective (697,
729)
Core temperature sensor defective (699, 700)
Fan defective. Cooking program was cancelled
(701)
Fan defective or temperature limiter triggered
(702)
Top fan defective. Automatic switching to
emergency operation (703, 705)
Bottom fan defective. Automatic switching to
emergency operation (704, 706)
Water pressure too low (709)
Water pressure during WaveClean too low
Water vapor sensor defective (710)
Internal core temperature sensor defective (714,
716)
External core temperature sensor defective (715,
717)
5007: Not enough storage space for software
update
5008: No new version found
5009: The application could not be started.
Application is restarting.
5010: The application could not be started.
Restore configuration backup?
5013: Application could not be restored! Restore
to factory settings with OK.
FAN_ID23: Fan error: Attempt to restart
FAN_ID24: Upper fan fault: Attempt to restart
FAN_ID25: Lower fan fault: Attempt to restart
GAS_ID13: Flame fault during operation
Service-instructions