5009: The Application Could Not Be Started. Application Is Restarting - Henny Penny FlexFusion FPG-221 Service Instructions Manual

5009: The application could not be started. Application is restarting.

Troubleshooting
Check content and structure of the USB stick.
Ensure that the USB interface is functioning properly.
On USB sticks with an LED, the LED must be on.
Check communication, e.g. by exporting HACCP data
Use a different USB stick
If the message appears after a software update, confirm by pressing
"OK". In individual cases, this may be required several times.
Description
The software does not boot. There is a fault in the communication or
the software is damaged.
Troubleshooting
Confirm the message with " OK ".
The software is restarted.
The error may appear twice. Repeat the procedure. If the error still
appears, proceed according to troubleshooting. With software
version 1.78 (10/2018) or higher, a restore is possible by means of
a rescue tool. Contact the manufacturer in this regard.
Service-instructions
Fault messages & troubleshooting
107