Door Is Open - Cooking Program Was Stopped - Henny Penny FlexFusion FPG-221 Service Instructions Manual

Fault messages & troubleshooting

Door is open - cooking program was stopped

110
Check the electrical connections and screw connections in the
area of the mains connection terminal, transformer and power line
to the control board.
Replace control board. It supplies voltage to the operating panel.
Replace transformer.
Replace operating panel.
Description
During fault-free operation, this message appears if the cooking
chamber door is opened during an active cooking program. If the
message is displayed with a closed cooking chamber door, there is
an error on the reed contact switch or door magnet.
Overview
a
a Reed contact switch
Troubleshooting
The operating state of the reed contact switch can be checked in the
status overview.
1. Open cooking chamber door. Check reed contact switch operation
with external magnet.
The magnet is not detected. Check reed contact switch and
replace if necessary.
The magnet is detected. Check magnet in cooking chamber
door for correct position and replace if necessary.
Service-instructions
b
b Door magnet