Starting The Cooking Program; End The Program - Henny Penny ClassicCombi Operating Instructions Manual

Operation
S to
P AS

4.6.3 Starting the cooking program

4.6.4 End the program

32
10. To save the changes, press FL E X I ( 2 ) until display (9) shows "Sto"
( "Store").
Display (9) shows "PAS" ( "Password").
Display (8) shows "0".
0
11. Press St e p (1 3 ) to exit the setup menu.
1. Select the cooking mode with one of the following buttons:
- C o m bi s t e a mi n g (3 )
- R e g e n e ra t io n (4 )
- C o nve c t io n (1 1 )
- S t e a min g (1 2 )
The LEDs for the cooking mode button are lit.
Display (9) flashes the preset cooking temperature.
Display (8) flashes the cooking time.
2. Set the cooking temperature.
3. Set the cooking time or target core temperature.
4. Set the "Crisping control" (optional) function.
5. Load the unit.
6. Insert the core temperature sensor into the food to be cooked (see
Chapter "Measuring the core temperature", Page
7. Press S t a r t / St o p (5 ).
The St a r t/ S t o p (5 ) LEDs flash.
Display (9) shows the set cooking temperature. A dot next to the cooking
temperature indicates that the heat is switched on.
Display (8) shows the remaining cooking time or the target core
temperature.
At the end of the cooking time or when the target core temperature is
reached, the program will be ended automatically and the LEDs for the
cooking mode button go out.
You can also end a program prematurely.
1. Press S t a r t / St o p ( 1 5 ).
The program will be terminated.
A signal sounds and the lighting in the cooking chamber flashes.
Operating instructions
ClassicCombi
34).
Global Foodservice Solutions
™