2.2 Adjusting Print Head Height
Adjust the print head height to suit media thickness.
• The print head height can be adjusted to one of three settings to suit the requirements.
Range
Low
High
• The print head height should normally be set to 2.0 mm. If the gap exceeds 2.5 mm, the ink
droplets may vaporize before reaching the media. Vaporized ink will adhere to the print head
nozzle surface and cooling fan filter. The amount of reflected light incident on the print head
surface from the UV-LED unit will also increase. Reflected light may cure vaporized ink adhering
to the nozzle surface. This will increase viscosity, reduce print quality, and generate print head
faults.
1
In LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Platen Right End ], then press the [ENTER] key.
• The carriage moves over the platen.
3
Open the front cover.
4
Unscrew the carriage cover screws.
• Use a flathead screwdriver to unscrew by approximately one turn.
Gap between print head and platen
2 mm (default setting)
2.5 mm
51
Chapter 2 Printing
2