Table of Contents
Advertisement
Mobile X-ray Unit
Operation
3.2.1.2
ON/OFF BUTTON + KEYPAD SYSTEM
2
1
5
.
Note
52
To turn the unit ON, proceed as described in the following steps:
1.
Press and hold the ON/OFF button (1) for a few seconds; the System
ON/OFF Indicator (2) will blink white for 5 seconds.
2.
Enter the four-digit Access Code into the Keypad (3), within 5 seconds
from turning the unit ON, and press the OK button (4); the System
ON/OFF Indicator (2) will light cyan and the Battery Charge Level
Indicator (5) will light according to the current battery status.
3.
When the system is ON, the System ON/OFF Indicator (2) will light white.
3
4
The system emits 3-beeps and the System ON/OFF Indicator
Indicator (2) blinks orange to indicate that a wrong code has been
entered; in this case, repeat the ON/OFF process.
The system in the ON status switches ON the Generator, allowing the Mobile
motion and then, Konica-Minolta "Ultra" Software Application for Radiographic
operation will be launched on the Control Console.
OM-0481R1
Advertisement
Table of Contents
