Mains Connection - Konica Minolta mKDR Xpress Operation

Mobile X-ray Unit
Operation
3.1

MAINS CONNECTION

.
Note
44
The Unit should be plugged into a wall socket compliant with local regulations
and electrical requirements of the equipment.
The plug is the device used as a means of disconnecting the Unit from mains.
Position the Unit so that the plug can be easily disconnected.
Refer to Section 8 for Technical Specifications.
For safety reasons and for proper functioning, make sure that
the unit is connected to a standard outlet with GND.
THE MOBILE UNIT OPERATES AT AN UNIVERSAL INPUT
RANGE FROM 100 V~ TO 240 V~ THAT MAY BE LIMITED BY
THE POWER LINE CABLE AND/OR PLUG ACCORDING TO
THE LOCAL REGULATIONS.
THE MAIN FUSES INSTALLED IN THE UNIT TO PROTECT THE
EQUIPMENT ARE FACTORY SET ACCORDING TO THE
COUNTRY DESTINATION AND ITS LOCAL REGULATION.
PLEASE, CONTACT TO THE SERVICE PERSONNEL OR
MANUFACTURER
CHANGED AND
DIFFERENT BECAUSE THE EQUIPMENT MAY NOT BE
PROPERLY PROTECTED.
IN CASE THAT
ELECTRICAL REQUIREMENTS
Plug
DESTINATION IS
ARE
OM-0481R1