Konica Minolta mKDR Xpress Operation page 71

COLORS
NOT MOVING MOVING
LIGHT OFF BLINKS WHITE
BLINKS WHITE
CYAN
--
GREEN
--
YELLOW
ORANGE BLINKS ORANGE
--
BLINKS MAGENTA
RED BLINKS RED
.
Note
OM-0481R1
SYSTEM STATUS SYSTEM STATUS
SYSTEM STANDBY
X-rays are disabled.
The Status Light Indicator is OFF when the system is in Standby.
It blinks white when the system is moving.
SYSTEM READY FOR EXPOSURE
The Status Light Indicator lights solid cyan when the system is ready, i.e., the user only
needs to press the Handswitch for making an exposure: the Detector is ready, the RAD
technique is correctly set, and there is not System Error or Interlock condition.
It blinks white when the system is moving.
SYSTEM PREPARED FOR EXPOSURE
The Status Light Indicator lights solid green when the handswitch has been pressed
halfway to the "Prep" status.
Movements are not allowed.
EXPOSURE ON
The Status Light Indicator lights solid yellow during the X-ray Exposure: the Handswitch
has been fully pressed to the "Exp" status.
Movements are not allowed.
SYSTEM ERROR
The Status Light Indicator lights solid orange indicating that there is a system Error and it
blinks orange when it is moving.
The Status Light Indicator blinks orange too when the system has been at a Battery Critical
Low status for 25 minutes, without being connected to mains.
FRONT BUMPER ACTIVATED
The Status Light Indicator blinks magenta when the Front Bumper is activated.
SERVICE MODE
Only in Service Mode.
For further information, refer to Section 3.4 about the Exposure
process and to Section 5 about System Messages.
Mobile X-ray Unit
Operation
63