Table of Contents
Advertisement
.
Note
OM-0481R1
Take the Remote Exposure Control device out of its cradle. Aim the Remote
Control at the IR Receiver Sensor on the Mobile unit from a maximum
distance of 10 meters.
3
2
1
COLLIMATOR LIGHT BUTTON:
Press this push-button to turn on the Collimator Light.
The status LED lights cyan.
EXPOSURE CONTROL:
Press this button halfway to prepare the X-ray Tube for exposure ("Prep"
position). When the X-ray Tube is "Ready" (green light on, at the Control
Console), fully press and hold this button ("Exp" position) until the X-ray unit
completes the exposure (yellow light on, at the Control Console).
The status LED lights cyan in "Prep" and "Exp" positions.
The preparation cycle automatically aborts and returns to Stand-by Mode if an
exposure is not initiated within 15 seconds after the "Prep" command or if the
Collimator Light is turned ON during this cycle.
The exposure aborts if the "Exposure" button is released.
When the exposure is completed the icon on the console turns OFF.
Return the Control Remote device back to its cradle on the Mobile unit.
For further information, refer to Section 3.2.10 of Status Light
Indicators.
Mobile X-ray Unit
1
OFF / Prep / Exp
2
Collimator Light
3
Status LED
Operation
67
Advertisement
Table of Contents
