Electromagnetic Compatibility (Emc) - Konica Minolta mKDR Xpress Operation

2.8

ELECTROMAGNETIC COMPATIBILITY (EMC)

OM-0481R1
This equipment generates, uses, and can radiate radio frequency energy.
The equipment may cause radio frequency interference to
other medical
communications.
To provide reasonable protection against such interference, this equipment
complies with emissions limits for a Group 1 -- Class A Medical Devices as
stated in EN 60601-1-2: 2007 and IEC 60601-1-2:2014. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment is found to cause interference (which may be determined by
turning the equipment on and off), the operator (or qualified service personnel)
should attempt to correct the problem by one or more of the following measures:
reorient or relocate the affected device,

increase the separation between the equipment and the affected device,

power the equipment from a source different from that of the affected

device,
consult the service engineers for further suggestions.

To comply with the regulations applicable to an electromagnetic interference for
a Group 1 - Class A Medical Device, all interconnect cables to peripheral
devices must be shielded and properly grounded. Use of cables not properly
shielded and grounded may result in the equipment causing radio frequency
interference in violation of the European Union Medical Device Directive and of
Federal Communications Commission regulations (FCC).
Before using this equipment make sure that all requirements
about EMC included in this manual are accomplished.
Should any interference (EMC) be detected with other
equipment, please position other equipment away from this
one.
or non-medical devices
Mobile X-ray Unit
Operation
and radio
27