Konica Minolta mKDR Xpress Operation page 157

C.1 INTRODUCTION
.
Note
.
Note
Appendix C
This Appendix only applies to Units equipped with RFID ON/OFF
System.
Administrator users have permissions to access certain system settings from
both the Acquisition Software and the Head-Assembly Console.
Administrator users can access a specific window of the Head-Assembly
Control Console (Service Mode Protection) where several Administrator
settings for Base Unit can be managed. Refer to Section C.2 of this Appendix
for detailed information.
Use the corresponding RFID Card to turn on the unit and access the software
with Administrator permissions. (Refer to System ON Section in the Operation
Manual for detailed information).
Depending on the installed Acquisition Software or Customer
Configuration, the appearance of the graphical interface may be
different from the one shown in these illustrations.
Mobile X-ray Unit
Operation
C-3