Mounting An Ex3200 Switch On Two Posts In A Rack Or Cabinet; Figure 24: Attaching Rubber Feet To An Ex3200 Switch Chassis - Juniper EX3200 Hardware Manual

EX3200 Switch Hardware Guide
Related
Documentation

Mounting an EX3200 Switch on Two Posts in a Rack or Cabinet

112

Figure 24: Attaching Rubber Feet to an EX3200 Switch Chassis

Connecting AC Power to an EX3200 Switch on page 129
Connecting DC Power to an EX3200 Switch on page 131
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 145
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 148
Clearance Requirements for Airflow and Hardware Maintenance for EX3200 Switches
on page 66
You can mount an EX3200 switch on two posts of a 19-in. rack (either a two-post or a
four-post rack) or a 19-in. cabinet by using the mounting brackets provided with the
switch. (The remainder of this topic uses "rack" to mean "rack or cabinet.")
You can mount the switch on four posts of a four-post rack by using the mounting brackets
provided with the separately orderable four-post rack-mount kit. See
EX3200 Switch on Four Posts in a Rack or Cabinet" on page
NOTE: If you need to mount the switch in a recessed position on either a
two-post rack or a four-post rack, you can use the 2-in.-recess front brackets
provided in the separately orderable four-post rack-mount kit.
Before mounting an EX3200 switch on two posts in a rack:
Verify that the site meets the requirements described in
for EX3200 Switches" on page
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines" on page
Remove the switch from the shipping carton (see
page 105).
"Site Preparation Checklist
57.
209, with particular attention
218.
"Unpacking an EX3200 Switch" on
Copyright © 2017, Juniper Networks, Inc.
"Mounting an
114.