Mounting An Ex4200 Switch On Two Posts In A Rack Or Cabinet; Figure 30: Attaching Rubber Feet To An Ex4200 Switch Chassis - Juniper EX4200 Hardware Manual

EX4200 Switch Hardware Guide
Related
Documentation

Mounting an EX4200 Switch on Two Posts in a Rack or Cabinet

160

Figure 30: Attaching Rubber Feet to an EX4200 Switch Chassis

Connecting AC Power to an EX4200 Switch on page 177
Connecting DC Power to an EX4200 Switch on page 179
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 195
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 198
Clearance Requirements for Airflow and Hardware Maintenance for EX4200 Switches
on page 72
You can mount an EX4200 switch on two posts of a 19-in. rack (either a two-post or a
four-post rack) or a 19-in. cabinet by using the mounting brackets provided with the
switch. (The remainder of this topic uses "rack" to mean "rack or cabinet.")
You can mount the switch on four posts of a four-post rack by using the mounting brackets
provided with the separately orderable four-post rack-mount kit. See
EX4200 Switch on Four Posts in a Rack or Cabinet" on page
NOTE: If you need to mount the switch in a recessed position on either a
two-post rack or a four-post rack, you can use the 2-in.-recess front brackets
provided in the separately orderable four-post rack-mount kit.
Before mounting the switch on two posts in a rack:
Verify that the site meets the requirements described in
for EX4200 Switches" on page
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines for EX4200 Switches" on page
Remove the switch from the shipping carton (see
page 153).
"Site Preparation Checklist
61.
267, with particular attention
"Unpacking an EX4200 Switch" on
Copyright © 2015, Juniper Networks, Inc.
"Mounting an
163.
277.