Mounting An Ex2200 Switch On Two Posts In A Rack Or Cabinet; Figure 14: Attaching Rubber Feet To A Switch Chassis - Juniper EX2200 Complete Hardware Manual

Related
Documentation

Mounting an EX2200 Switch on Two Posts in a Rack or Cabinet

Copyright © 2010, Juniper Networks, Inc.

Figure 14: Attaching Rubber Feet to a Switch Chassis

Connecting AC Power to an EX2200 Switch on page 73
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 87
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 89
Clearance Requirements for Airflow and Hardware Maintenance for EX2200 Switches
on page 42
You can mount the switch on two posts of a 19-in. rack or cabinet by using the mounting
brackets provided with the switch. (The remainder of this topic uses "rack" to mean "rack
or cabinet".)
You can mount the switch on four posts of a four-post rack by using the mounting brackets
provided with the separately orderable four-post rack-mount kit. See "Mounting an
EX2200 Switch on Four Posts in a Rack or Cabinet" on page 57.
NOTE: If you need to mount the switch in a recessed position on either a
two-post rack or a four-post rack, you can use the 2-in.-recess front mount
brackets provided in the separately orderable four-post rack-mount kit.
Before mounting the switch on two posts in a rack:
Verify that the site meets the requirements described in "Site Preparation Checklist
for EX2200 Switches" on page 33.
Place the rack in its permanent location, allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Read "General Safety Guidelines and Warnings for EX Series Switches" on page 113,
with particular attention to "Chassis Lifting Guidelines for EX2200 Switches" on page 128.
Remove the switch from the shipping carton (see "Unpacking an EX2200 Switch" on
page 52).
Ensure that you have the following parts and tools available:
Rubber feet
Chapter 8: Installing the Switch
55