Table of Contents
Advertisement
Chapter 9: Powering On the Chassis
180
3. Use the twist tie that comes with the power supply to secure the cord
to an anchor on the chassis, as shown in Figure 109.
Figure 109. Securing the Power Cord for the AT-SBxPWRPOE1 Power
4. Connect the power cord to an appropriate AC power source to power
on the power supply.
5. If the chassis has two AT-SBxPWRPOE1 Power Supplies, repeat this
procedure to power on the second power supply.
Figure 110 on page 181 is an illustration of the power cords for a
chassis with four power supplies.
Supply to an Anchor
Advertisement
Table of Contents
