Table of Contents
Advertisement
Figure 94. Removing the Dust Cover from an SFP or SFP+ Slot
Note
Do not remove the dust plug from a transceiver slot if you are not
installing the transceiver at this time. The dust plug protects the line
card from dust contamination.
3. Slide the transceiver into the slot until it clicks into place.
To install the transceiver into an odd numbered slot, position it with the
handle is on top as you slide it into the slot. To install the transceiver
into an even numbered slot, position it with the handle on the bottom.
Refer to Figure 95 on page 159.
Handle
Figure 95. Inserting an SFP or SFP+ Transceiver
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
159
Advertisement
Table of Contents
