Table of Contents
Advertisement
Chapter 8: Installing Transceivers and Cabling the Ports
Installing AT-QSFPCU Cables
166
This section contains instructions on how to install AT-QSFPCU Cables in
the AT-SBx81XLEM/Q2 Expansion Module for the AT-SBx81XLEM Line
Card. You can use the cables in place of fiber optic cables and
transceivers for 40GbE links of up to 1 or 3 meters. The model names of
the cables are listed here:
AT-QSFP1CU - 1 meter
AT-QSFP3CU - 3 meters
Note
The AT-QSFPCU Cables are only supported in the AT-SBx81XLEM/
Q2 Expansion Module.
Please review "Guidelines to Installing SFP, SFP+, or QSFP+
Transceivers" on page 157 before performing this procedure.
To install AT-QSFPCU Cables, perform the following procedure:
1. Remove the dust cover from a slot on the AT-SBx81XLEM/Q2
Expansion Module. Refer to Figure 103.
Figure 103. Removing the Dust Cover from a Slot on the AT-SBx81XLEM/
2. Orient the connector on the AT-QSFPCU Cable with the release tab
on top and slide it into the slot until it clicks into place. Refer to Figure
104 on page 167.
Q2 Expansion Module
Advertisement
Table of Contents
