Table of Contents
Advertisement
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
6. Lower the power supply locking handle to secure the power supply to
the chassis, as shown in Figure 51.
Figure 51. Lowering the Handle on the AT-SBxPWRSYS1 or AT-
SBxPWRSYS2 AC System Power Supply
Note
If the module does not fully seat in the chassis slot, check to be sure
you are installing a system power supply and not a PoE power
supply. The model name of the module is included on a label on the
locking handle. For more information, refer to "Power Supplies and
Power Supply Slots" on page 24.
7. To install a second system power supply, repeat this procedure.
8. After installing the AT-SBxPWRSYS1 or AT-SBxPWRSYS2 AC
System Power Supples, do one of the following:
If you purchased the AT-SBxPWRPOE1 Power Supply for the
ports on the AT-SBx81GP24 PoE Line Cards, go to "Installing AT-
SBxPWRPOE1 PoE Power Supplies" on page 117.
Otherwise, go to Chapter 7, "Installing the AT-SBx81CF400
Control Card and Ethernet Line Cards" on page 129.
115
Advertisement
Table of Contents
