Table of Contents
Advertisement
Chapter 7: Installing the AT-SBx81CF400 Control Card and Ethernet Line Cards
142
8. Carefully align the expansion module in the slot, as shown in
Figure 78, and slide it into the line card.
Caution
Keep the module level with the line card as you slide it into the slot.
You might damage the components on the top or bottom of the
module if you slide it in at an angle. Refer to Figure 64 on page 131.
Caution
Do not force the card into the slot. If you feel resistance, remove the
card and try again.
Figure 78. Sliding the Expansion Module into the AT-SBx81XLEM Line
9. When the expansion module makes contact with the connector inside
the line card, gently press on both sides of the faceplate to seat the
module on the connector. Refer to Figure 79 on page 143. The module
is fully installed when its faceplate is flush against the faceplate of the
AT-SBx81XLEM Line Card.
Card
Advertisement
Table of Contents
