Connecting The Grounding Wire With Bare Wire; Figure 117: Stripping The Solid Or Stranded Grounding Wire; Figure 118: Attaching The Bare Grounding Wire To The Grounding Post - Allied Telesis AT-SBx81CFC400 Installation Manual

Connecting the
Grounding Wire
with Bare Wire
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
To attach the grounding wire to the power supply with bare wire, perform
the following procedure:
1. Prepare an adequate length of solid or stranded 10 AWG grounding
wire by stripping it as shown in Figure 117.
Figure 117. Stripping the solid or Stranded Grounding Wire
2. Use an 8 mm wrench to remove the grounding post nut and washer,
shown in Figure 115 on page 185, from the grounding post on the
power supply.
3. Wrap the grounding wire clockwise around the base of the grounding
post, as shown in Figure 118.
Figure 118. Attaching the Bare Grounding Wire to the Grounding Post
187