Table of Contents
Advertisement
Installing AT-SP10TW Direct Connect Cables
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
This procedure explains how to connect AT-SP10TW direct connect
Twinax cables to the SFP+ slots in the following devices:
AT-SBx81XS6 Line Card
AT-SBx81XLEM/XS8 Expansion Module
The cables may be used in place of fiber optic cables and transceivers for
10 Gbps links of up to 7 meters.
Note
The AT-SP10TW Cables are not supported in the AT-SBx81GS24a
Line Card or slots 1 to 12 in the AT-SBx81XLEM Line Card.
Please review the information in "Guidelines to Installing SFP, SFP+, or
QSFP+ Transceivers" on page 157 before performing this procedure.
The illustrations show the AT-SBx81XS6 Line Card. The procedure is the
same for all supported devices.
To install AT-SP10TW Cables, perform the following procedure:
1. Remove the dust plug from an SFP+ slot. You may install AT-SP10TW
Cables in any of the slots in the line card or expansion module. Refer
to Figure 100.
Figure 100. Removing the Dust Cover From an SFP+ Slot
163
Advertisement
Table of Contents
