Table of Contents
Advertisement
Installing AT-SBxPWRPOE1 PoE Power Supplies
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
This section contains the installation procedure for the AT-SBxPWRPOE1
Power Supply, for the PoE+ ports on the AT-SBx81GP24 PoE Line Card.
For background information, refer to "Power Supplies and Power Supply
Slots" on page 24.
Caution
The electronic components in the power supply can be damaged by
electro-static discharges (ESD). Follow the procedure in "Protecting
Against Electrostatic Discharge (ESD)" on page 110 to guard
against ESD damage when unpacking and installing the power
supply.
To install the power supply, perform the following procedure:
1. Choose a slot for the AT-AT-SBxPWRPOE1 System Power Supply in
the chassis.
You may install it in either slot A or B, shown in Figure 46 on page 112.
2. Raise the handle on the blank panel covering the selected slot and
slide the panel from the chassis. Figure 52 on page 118 illustrates the
removal of the blank panel from slot A.
117
Advertisement
Table of Contents
