Table of Contents
Advertisement
Powering On AT-SBxPWRPOE1 Power Supplies
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC400 Card Installation Guide
If you have not already installed the AT-SBxPWRPOE1 Power Supplies,
refer to "Installing AT-SBxPWRPOE1 PoE Power Supplies" on page 117
for installation instructions. To power on the power supplies, perform the
following procedure:
1. Identify AC sockets A and B in the recessed panel on the back panel of
the chassis, shown in Figure 105 on page 176. The sockets are for the
AT-SBxPWRPOE1 Power Supplies in slots A and B on the front panel
of the chassis.
2. Plug the AC power cord that comes with the power supply into one of
the plugs, as shown in Figure 108.
The plug should have a power supply in the corresponding slot in the
front panel. If the chassis has two AT-SBxPWRPOE1 Power Supplies,
you may power on either supply first.
Figure 108. Connecting the AC Power Cord for the AT-SBxPWRPOE1
Power Supply
179
Advertisement
Table of Contents
