Table of Contents
Advertisement
Chapter 7: Installing the AT-SBx81CF400 Control Card and Ethernet Line Cards
Installing the Ethernet Line Cards
146
This section contains the installation procedure for the Ethernet line cards.
The illustrations show the AT-SBx81GP24 Line Card, but the procedure is
the same for all the cards.
Note
Please review "Guidelines to Handling the Controller and Line
Cards" on page 130 before performing this procedure.
This procedure requires the following tools:
#2 Phillips-head screwdriver (not provided)
#2 Phillips-head, 5 inch-lbs torque screwdriver (optional — not
provided)
To install the Ethernet line cards, perform the following procedure:
1. Choose a slot in the chassis for the Ethernet line card. The Ethernet
line cards can be installed in slots 1 to 4 and 7 to 12. The slots are
shown in Figure 84.
Slot 1
Slot 3
Slot 7
Slot 9
Slot 11
Figure 84. Slots 1 to 4 and 7 to 12 for the Ethernet Line Cards
2. If the selected slot for the line card is covered with a blank slot cover,
use a #2 Phillips-head screwdriver to loosen the two captive screws on
the cover and remove it from the chassis. Refer to Figure 85 on page
147.
Slot 2
Slot 4
Slot 8
Slot 10
Slot 12
Advertisement
Table of Contents
