Chapter 8: Installing Transceivers and Cabling the Ports
162
6. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 99. The connector should snap into the port.
Figure 99. Attaching a Fiber Optic Cable to a Transceiver
7. Repeat this procedure to install additional transceivers.
8. After installing and cabling the transceivers, do one of the following:
To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
After cabling all the ports in the chassis, go to Chapter 9,
"Powering On the Chassis" on page 173.